| Comments | 2007 RX-700 with 2,383 hours.Equipped: Caterpillar C18 6 cylinder diesel engine (700 HP), 86” (2.18m) Kennametal KPF 301 quick change triple wrap drum, 14” (356mm) cutting depth with sloped front and rear moldboards, 36” (914mm) lower primary conveyor belt (endless belt), 36” upper conveyor belt (endless belt in good condition) - 60˚ swing to either side, “Extended Wear”
cutter housing with 500 BHN Liners, three track system w/ 14” front and 16” rear B4-HD tracks, Moba non-
contacting sonic averaging ski (dual sonic ski sensors (five eye), dual wire rope sensors, dual standard junction boxes, dual big ski junction boxes, dual global connectors, slope sensor), joy stick controls with
four coordinated steering modes, hydraulic side plate lifters with replaceable wear shoes, ground level elevation controls for moldboard, end gates and elevation, high pressure wash down system with retractable spray hose, air compressor with reservoir and air tools (two storage takes and compressor for use of air tools for service or tooth changing, remote grease fittings arranged in zones, light package consisting of ten (10) 24 volt light, bolt-on replaceable poly insert track pads, six 24 VDC power outlets, automatic drive belt tensioning, 1100 Gallon water tank with three filling stations.
 |
Back 
