| Comments | 2000 Roadtec RX-60C with 9502 hours on the frame with 3151 hours on the engine. Equipped: Cummins QSK (800 HP), 86” (2.184 m) Sollami drum, 12” (305mm) cutting depth, 42” (1.067m) primary conveyor belt (endless belt in good condition), 42” (1.057m) upper discharge conveyor (conveyor swings 50
degrees to either side, seamed belt in good condition), three heavy duty D-5 size tracks with 16” (406mm)
grousers, bolt on poly track pads, dual Moba sonic grade controls, electronic over hydraulic slope control,hydraulic side plate lifters, ground level moldboard controls, ground level elevation controls, high pressure wash down, air compressor. Repairs: New Cummins engine installed 3,151 hours ago (Jan.06), new radiator and hoses installed (1/06), new front and rear steering pins and bushings (1/06), front and rear sprockets replaced (1/06), new power pack unit (1/06), new generator set (1/06). New endless primary conveyor belt installed (Spring 2009), new bolt on track pads (Spring 2006), new bushings in legs, new auxillary pump, new cutting edge, new tooth holders
and teeth installed on drum.
 |
Back 
